Shop headings: New Spares | Used Spares | Accessories | Brands
Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils
Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit
This part is due back in stock soon, call 01484 841395 to reserve yours
£28.00
INC VAT
£23.33 EX VAT
Regulator rectifier for Saprisa charging systems
Male spade connectors on regulator, may be supplied with 7 connectors - see the diagram on our technical documents page for help installing this part.
This part is due back in stock soon, call 01484 841395 to reserve yours
28703800-z 28703800 GU28703800 28 70 38 00
2870 3800 2870.3800 28.70.38.00
£85.00
INC VAT
£70.83 EX VAT
Silca key blank for ignition key, match profile to your existing key
This part is due back in stock soon, call 01484 841395 to reserve yours
NE5
£4.20
INC VAT
£3.50 EX VAT
Silca key blank for ignition key, match profile to your existing key
This part is due back in stock soon, call 01484 841395 to reserve yours
£4.20
INC VAT
£3.50 EX VAT
Reconditioned Valeo starter motor and solenoid in black and silver finish. Professionally reconditioned and sold with a 12 month guarantee. This is a suitable replacement for Bosch 8 or 9 tooth Guzzi starter motors. Minor modification may be required on some pre 1990 models to make room for the solenoid. Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology. See , see this link for the modifications required to fit a Valeo starter to a 4 speed model.
This is an exchange only item, we can supply these before receiving your exchange unit subject to a refundable deposit so you can keep your bike on the road. See ELC10737 for the refundable deposit. Send your old starter motor to our registered address.
NB In case of starter motor problems do not tap the casing as this will certainly cause it to fail. See SSA08075 for mounting bolts.
Also known as Guzzi ref. 30730710
Do not remove second nut from terminal posts when fitting - this nut is required to hold the terminal in place
Supercedes Guzzi refs. 12730705, 14730554 and 14730705
30730711 GU30730711 30 73 07 11
3073 0711 3073.0711 30.73.07.11
£155.00
INC VAT
£129.17 EX VAT
Neutral indicator switch
Availability varies on this part, check availability
12207200 GU12207200 12 20 72 00
1220 7200 1220.7200 12.20.72.00
£40.00
INC VAT
£33.33 EX VAT
Pair low and high chrome Voxbell horns. Rear of horn is black, two connection terminals on one horn, four on the other
This part is due back in stock soon, call 01484 841395 to reserve yours
14743700 GU14743700 14 74 37 00
1474 3700 1474.3700 14.74.37.00
Also fits Laverda
£87.00
INC VAT
£72.50 EX VAT
Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 3 Ohm 12 volt coils and can be used to replace points or Motoplat ignition on models with Saprisa charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.
2 year warranty on Sachse ignition kits
Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA31165
This part is available by special order, request a quote
£395.00
INC VAT
£329.17 EX VAT
Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.
This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.
Supercedes Guzzi refs. 12730705, 14730554 and 14730705
Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part
This part is due back in stock soon, call 01484 841395 to reserve yours
30730711 GU30730711 30 73 07 11
3073 0711 3073.0711 30.73.07.11
£231.00
INC VAT
£192.50 EX VAT
Complete round 203mm left hand dip (UK spec) headlight unit with bulb. Black body with chrome rim.
Due to the scarcity of LH dip Italian made headlights we have sourced this reasonably priced alternative which is similar in size to the headlamp used on V50 and T3 models. Supplied complete with headlight bulb. Headlamp is slightly larger than stock so some repositioning of the headlamp brackets may be required. Please note there is no pilot light with this headlamp and thread size for bolt fixing holes is M8. This is a smaller thread than the M10 thread on T3 indicator stems.
This part is available by special order, request a quote
£77.20
INC VAT
£64.33 EX VAT